Precautions for curtain rod installation? Curtain rod installation method?

The installation of curtain rods in modern society has also become a key part of home decoration. Many beginners may still not understand the installation of curtain rods. Among them, the installation method of curtain rods and The precautions are also worthy of people’s attention, so as not to cause a series of unnecessary troubles when the installation is wrong, today I will share with you about the curtain rod installation method and precautions.

 Curtain rod installation precautions?

  There are many aspects to pay attention to when choosing curtain rods.

 1. Level: The housing price is increasing, but the quality is declining. It is affordable housing and housing under construction. Some roofs are inclined by about 10cm. 5cm, the wall presents a trapezoidal shape. Therefore, it is best to use a level ruler and a level tube when installing a curtain rod.

 2. Roof height: In order to show the beauty of the exposed curtain rod, you must pay attention to the height of the top of the room and the window to avoid a sense of depression and suffocation. When installed on the wall, that is, the wall is installed, and the horse pole should be about 6cm to 12cm away from the roof and ceiling. When installed on the roof and ceiling, referred to as top installation, the Roman rod should be about 6cm to 10cm away from the wall, so as to prevent the curtain from rubbing against the wall and staining the curtain fabric when opening and closing the curtain.

 3. Leave room: During the installation process, the left and right sides of the window frame should not be lower than 6cm. Cover windows completely. When the curtain cloth covers the entire wall, the length of the Roman rod (excluding the decorative heads at both ends) is about 18-22cm shorter than the net width of the room. After installation, there is a gap of about 2-2 cm between the decorative head of the Roman rod and the wall. -6cm.

 How to install the curtain rod?

 We also need to pay attention to the installation method of the curtain rod during the installation process, so as not to error.

 Check the compatibility of the Roman pole and its support, decorative head, and hanging ring, and measure the length of the Roman pole and the width of the window. Use the installed support as a standard marking line to draw the support positioning line and hole position line. With 3 supports, the middle support is located on the window or wall, and the two ends are equidistant. The depth of the hole is 4-4.5cm. When punching, do not run away or skew. Note: keep away from wires and water pipes. After the hole is punched, knock the plastic expansion tube into the hole. The support is fastened with self-tapping screws; the rings are inserted into the rod, and the rings are divided into two, leaving 1-2 rings at each end; press the Roman rod into the open support and adjust so that the decorative heads at both ends are away from the wall the same distance. After the curtain is put on the hook, put the other end of the hook into the hole of the hanging ring; open and close the curtain left and right, check whether the sliding is flexible and whether the two curtains are of the same height. Otherwise, fine tune.

 The above is the small editor’s detailed introduction to the precautions for curtain rod installation? mistake.

Shopping Cart
Available for Amazon Prime