Generally speaking, curtain rods are made of metal and wood, which are favored by many families because they can be used to install curtains, reduce noise, and direct light. This building material product can be seen in many families. The following editor will introduce how to install the curtain rod and the matters needing attention in the installation of the curtain rod.
How to install the curtain rod
1. Install the curtain box
First determine the elevation according to the flat line, draw the center line of the curtain box, align the center line of the curtain box with the center line of the window when installing, stick the box against the wall tightly, and design the fixing method according to the individual.
2. Install curtain rails
Curtain rails can be divided into single, double or triple tracks. When the window width is greater than 2.3m, the curtain rail should be disconnected, and the bends at the disconnection should be staggered, and the bends should be gentle curves, and the lap length should not be less than 200mm. Ming curtain box generally installs the track first. Heavy curtain rails should be lengthened with screws; dark curtain boxes should be installed with rails. The distance between the small corners of the heavy curtain track should be increased. The normal matching method in the market is one meter with two installation codes. If the curtain is heavy, you can add more installation codes depending on the situation without affecting the pulling. The purpose is to ensure that the load-bearing is within a safe range. The size of the wood screw is not less than 30mm. The rails remain in a straight line after installation.
3. Install the curtain rod
Correct the connection fixture, install the rod or iron wire, and pull it on the fixture. Make it flat and exactly the same as the elevation of the room.
Precautions for curtain rod installation
1. Different connection methods are adopted depending on the situation
If the wall is made of wood, just put the The screws for installing the track can be directly eaten on the determined position of the plank. If the wall is made of cement, you need to use an electric drill to drill a hole in a certain position, then knock in the special nylon expansion tube, and then insert the screw into the special nylon expansion tube and tighten it.
2. Make sure the installation is firm
Don’t install it, it will fall off after a while. If the bracket is too small, the bracket may be easily damaged. On the other hand, if the bracket is too small, the contact surface between the wall and the wall will be small, and the number of nuts or the size of the nuts will be limited, which will easily make the installed curtain rod unstable. .
3. Ensure specification and level
The length of the curtain rod should be greater than the width of the window cover to avoid light leakage;
4. Timing for curtain rod installation
It is best to install the curtain rod after the new house has been opened up or before the last cleaning. It was thick with dust, and it was too late to clean up and wasted. At the same time, the Roman rod is best matched with the curtains, while the curtain rails can be installed in advance, and what kind of rails to install should be considered when the decoration is finished.
The above is the introduction of how to install the curtain rod and the precautions for the installation of the curtain rod. I hope it can be helpful for everyone to install the curtain rod. In fact, not only the classification and purchase of curtain rods has a lot of knowledge, but also the installation steps and skills of curtain rods have many points that need attention. We need to learn more before installation.
